AP1682 LED DRIVER DOWNLOAD

Since of PFC operation and the special PFM control technology, the circuit operation parameter of Flyback converter is little different with the traditional off-line Flyback converter. The rectified input voltage sensing pin. The pin is detecting the instantaneous rectified sine waveform of input voltage 3 VPK The rectified input voltage peak value sensing pin. This application notes emphasis on the Flyback power converter design with AP For PSR isolated LED driver, the transformer parameters determine the power converter operation status, so firstly transformer design should be frozen, including primary to secondary winding turns ratio, primary winding inductance, etc. The rectified input voltage peak value sensing pin.

Uploader: Mirisar
Date Added: 14 September 2004
File Size: 53.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33492
Price: Free* [*Free Regsitration Required]

As shown in Figure 5 and Figure 6, comparing to the Flyback application, the Buck-Boost converter has only inductor instead of transformer, has le primary snubber circuit. Complain wrong Brand wrong Model non readable. The most components of Flyback and Buck-Boost have same Apr.

The design specification is 8. To reduce start-up time, an acceleration start function is embedded in AP The FB pin resistor ap682 is used to detect output voltage so that the power board can operate at no load condition.

Load Regulation of Output Current 7.

Design Guideline and Application Notes of AP1682 System Solution

Use Voltage Divider Rule to find 1. FB voltage is used to control no load output lef and determine acceleration stop point at start-up phase. At start-up phase, after VCC voltage reaches turn on threshold, AP controls the power converter operating at the max frequency with DCM Boundary mode to provide more energy to output.

  E1505 VIDEO CARD DRIVER DOWNLOAD

BCD will release the AP design sheet tools for both Flyback and Buck-Boost application to meet the all types of application requirements. The pin is detecting the rectified sine waveform peak value of input voltage 4 CS Primary current sensing 5 FB This pin captures the feedback voltage from a;1682 auxiliary winding. The primary current sense pin. In order to achieve the DC average value of half a1p682 sine waveform, the low pass filter is necessary.

(PDF) AP1682 Datasheet download

From above output current equation it is concluded that the output current has the double line frequency AC components, which results in the double line frequency output sp1682 and output current ripple.

The pin is detecting the instantaneous rectified sine waveform of input voltage 3 VPK The rectified input voltage peak value sensing pin.

A ceramic capacitor C3 is paralleled between VS pin and Ground to bypass the high frequency noise. Begin from the central column of the Bobbin. High Voltage Demo Boards.

The AP achieves excellent regulation and high efficiency, yet meets the requirement of IEC harmonic standard. Supply voltage of gate driver and control circuits of the IC. The primary OCP comparator 4.

  CANON SCANNER N124OU DRIVER

It is assumed that the secondary diode forward voltage ap16822 Vd is about 0. So the AP also can be used in non-isolated Buck-Boost application.

From the Figure 3. Finish on Pin 2. Current return for gate driver and control circuits of the IC. The AP start-up voltage threshold is Physics Lab 5 Prelab Exercise: When open load condition or load disconnecting happens, the output voltage rises to the maximum value and the FB pin voltage reaches 4V.

Design Guideline and Application Notes of AP System Solution

The pin is detecting the instantaneous rectified sine waveform of input voltage. Ao1682 higher dynamic resistance RLED, the lower output ripple current, the lower required output capacitance.

Lee Parameter Components Selection Design design method. Therefore, a line compensation circuit is necessary to decrease or eliminate this gap and achieve the better output current accuracy.

For PSR isolated LED driver, the transformer parameters determine the power converter operation status, so firstly transformer design should be frozen, including primary to secondary winding turns ratio, primary winding inductance, etc.