If necessary, relocate the IDE devices in the computer to allow the cable to connect them to the motherboard. Make sure that one device is jumpered as master, and one is jumpered as slave. The reference manual for the computer has information on how to remove the cover. Click Start , and then click Run. The location for the master jumper pin on one device is not necessarily the location for the master jumper pin on another device. Only two IDE devices can be connected per cable for each channel See the “Determine jumper settings” section below.
|Date Added:||27 May 2004|
|File Size:||64.28 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
To determine what each vertical pair of pins represents on another IDE device, refer to the documentation that came with that device. Turn the computer on. Generally, if there are screws attaching the cover, they are on the back of the computer. The devices should redetect after the jumpers are set correctly. Some computers may require configuration changes in the BIOS specific to the IDE settings before Windows will detect the device and assign a drive letter.
Up problems that can be seen from incorrect cabling include no device detection, misdetection of either device on a shared cable, slow cdd boot up, system halts while booting, and loss or misdetection of devices on the other IDE channel.
HP CD Writer CD52 52 Cd-r 32x Cd-rw 52x ROM
The reference manual for the computer has information on how to remove the cover. Only two IDE devices can be connected writdr cable for each channel See the “Determine jumper settings” section below.
The location for the master jumper pin on one device is not necessarily the location for the master jumper pin on another device. Please refer to documentation for any IDE devices in question.
Free Download HP CD52 Internal CD-Writer series drivers
Common problems and solutions There are some writeer problems or variations of these problems that can occur when one or more of the above steps are not properly completed. Anything longer than this will tend to degrade the signals coming down the lines of the cable.
Attach the cables Power cable The power plug can only be inserted in the correct direction, because the plug has a trapezoidal shape that prevents it from being inserted incorrectly Figure 2. Data cable connector on back of drive pin positioning. Find a way to install the devices so that the cables reach their connections using the standard length cable.
Locate a drive slot. As long as both devices are jumpered to Cable Select, the devices should work properly, but again, it is better to use a standard IDE cable, like the one that ships wriher most of the HP drives to avoid potential issues. Check the documentation for the sound card for information.
How does HP install software and gather data? Xd52 sure that one device is jumpered as master, and one is jumpered as slave. Some computer covers will not have screws and in these instances, there are levers on the covers to lock and unlock the case.
Unplug the IDE cable, determine pin-1 for all plugs, and reconnect the cable. Common problems and solutions. Pin 1 is identified by the colored stripe along one edge of the data cable.
IDE cable is too short The IDE specification requires that the cable be inch from the motherboard to the first plug, and 6-inch from the middle plug to the end plug. See your browser’s documentation for specific instructions.
HP CD Writer CD52 52 Cd-r 32x Cd-rw 52x ROM | eBay